SIMPSON CM61083 Clean Machine 3400 PSI Gas Pressure Washer - 2.5 GPM, CRX Engine with Spray Gun, Wand & 4 QC Nozzle Tips - 5/16-in x 25-ft MorFlex Hose - Heavy Duty Power Washer for Driveway Cleaning, Deck Washing, House Exterior & Concrete Surfaces (49-State Compliant)

So out of the box this washer is pretty basic - no accessories other than 4 nozzles. I added some stainless steel quick disconnects, a 50 foot hose extension, a cheap foam cannon, the Simpson in-line pressure regulator, and a 15 inch surface cleaner.This is a bargain and worth every penny even without those accessories. The power is amazing. The engine started on the second pull. It is relatively quiet for a gasoline engine. I ran it through 2.5 gallons of gasoline in about 4 hours of continuous operation with zero issues.There is some preparation required before the first use - the big one is you need to add oil - which is included in a pre measured pouch - to the engine crankcase Do this before putting any gasoline in the tank and give the engine several pulls to lubricate things. Also, before you start the engine, connect the pump to the supply hose and turn on the water. Remove the nozzle from the spray wand and squeeze the trigger to purge and prime the pump and high pressure hose - this can take a few minutes to fully purge out the air. Once purged, make sure their is gasoline in the tank, the throttle is open, the fuel valve is open, the choke is closed, the kill switch is on and give the starter a pull. Once the engine has started, pull the spray wand trigger again to fully purge the pump. It may look and feel like the pump has low pressure - keep squeezing the trigger and give it a minute. You will hear the engine bog down and suddenly there is pressure. Add the spray nozzle and go to work!The only issue I had was mounting the spray wand holder. It he mounting hole is partially blocked by the “apron” between the handles. I had to loosen the Torx screws of the apron to get enough clearance for the bolt to go in the hole. Once it was through, the apron screws could be tightened up again. And the holder holds the wand very securely if you insert it and twist it to snap it in place. Maybe the newer machines have a redesigned holder based on other reviews stating the holder was “worthless”.Based on my experience so far, I would recommend this machine - it is more than adequate for home use. The build quality is very good, the frame is strong, the engine is great, and the performance is awesome. Hopefully it lasts years with moderate use.